Please note that these are approximate sizes depending on how accurate you are. The most accurate way to measure your ring size is to go to your local jeweller and have your figure measured and sized.

If that is not possible please find below a couple of charts that you might find handy.

In order to print the ring sizer below, be sure that your printer is set to a full 100%. Make sure that you have not reduced the print size in your printer “page setup” area. You can make sure that the sizer printed correctly by measuring it with a ruler, it should measure from A to B: 3 ½ inches long.

Once you have printed the sizer, please follow the directions to find your ring size:-

1. Cut out the ring sizer.
2. Cut a slit for Slot “A”
3. With the numbers facing out, wrap the sizer around the finger where the ring will be worn.
4. Pull the pointed end Tab “B” through Slot “A” until the sizer is snug, making sure to allow size for the knuckle.
5. The number aligned with Slot “B” is your ring size.
6. If the measure lands between two numbers your size is a half size. Eg between 5 and 6 ring size 5.5. When half sizes are not available go to the next largest size.       

 Below you will find a chart with comparable sizes from different countries to help you.